HDMI Cable Tester
The PITS-PR19 provides a 9-volt DV continuity test on all the HDMI cable's active pins, proceeding through the pins automatically or one button press at a time. Any faults detected are identified as open, short, or reverse by a 3-color LED. Each TMDS channel (positive wire, negative wire, and shield wire), the CEC, SCL, and SDA channels, the +5V channels, and the HPD channel are tested. The PITS-PR19 can perform both loopback tests on uninstalled cables and remote tests on installed cables.
Descriptions
An HDMI connector has 19 pins. The PITS-PR19 test all pins except pin 14 (the "Reserved pin"). The PITS-PR19 places three pins at a time in series and tests them together; the color of the LED indicates the nature of any fault detected, and which wire (positive, negative, or shield) it is on. Thus, LED 1 tests pins 1-3 (red data), LED 2 tests pin 4-6 (green data), LED 3 tests pins 7-9 (blue data), and LED 4 test pins 10-12 (clock). LED 5 tests pins 13 and 17 (CEC and the CEC ground pin). Pins 15, 16, 18, and 19 (SCL, SDA, +5V, and HPD) are all tested independently. This means the PITS-PR19 can test an entire HDMI cable using only 9 circuits.
Features
Select automatic or step (one button press at a time) testing
Remote unit enables tests of installed as well as uninstalled cables
3-color LEDs indicate the nature of detected faults - open, short, or reverse
Remote unit attaches to transmitter for easy portability
Part No. PITS-PR19
|
